Crypto WF200 Guía de instalación descargar pdf (Pagina 22)

WF200 802.11g Wireless Router

IP address: Fill in IP address 192.168.1.x (x is a number between 2 to 254).

Subnet mask: Default value is 255.255.255.0.

Default gateway: Default value is 192.168.1.1.

Preferred DNS server: Fill in preferred DNS server IP address.

Alternate DNS server: Fill in alternate DNS server IP address.

You can use ping command under DOS prompt to check if you have setup TCP/IP protocol correctly

and if your computer has successfully connected to this router.

2) Type ping 192.168.1.1 under DOS prompt and the following messages will appear:

Pinging 192.168.1.1 with 32 bytes of data:

Reply from 192.168.1.1: bytes=32 times<2ms TTL=64

Reply from 192.168.1.1: bytes=32 times<1ms TTL=64

Reply from 192.168.1.1: bytes=32 times<10ms TTL=64

If the communication link between your computer and router is not setup correctly,

after you type ping 192.168.1.1 under DOS prompt following messages will appear:

Pinging 192.168.1.1 with 32 bytes of data:

Request timed out.

This failure might be caused by cable issue or something wrong in configuration procedure.

4. Configure Wireless ADSL2+ Router via HTML

This device supports a Web-based (HTML) GUI to allow users to configure Router setting via Web

browser.

4.1 Login

1) Launch the Web browser.

2) Enter the default IP address http://192.168.1.1

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 58 59

Sin comentarios

Crypto WF200 Guía de instalación Pagina 22